Hi ajbessinger, I’m looking forward to see how you’re going to mount the cooling manifolds remotely. 27ace27 mentioned how Ford addressed this issue in the 33.5 kWh packs by adding clamps to keep the cell stacks compressed. Are you planning on adding some sort of clamping system?
Thank you for your response. Yes the pumps do report the appropriate % response when being adjusted. Your guess that the pump return signal is a possible suspect is a good suggestion. I’ll start with inspection of the wires from the pump to the PCM and see if any of them are suspect or have...
Hiema, I too thank you for taking the time to post how to operate the pumps with forscan. I tried it out and was able to make all three of the pump function properly, but I am still getting DTC P2601 (pump "A" control module stuck/off) Do you have any suggestions what I might check on next...