UGH. I just spent too much time typing up all the details, only to lose it when I stepped away from my desk for a minute. Here goes again.
6 steps for the eyebrow LED lamp mod:
1. Remove both headlamps. 2 screws in each, use a flat-blade screwdriver.
2. Locate the wires for the LED lamps and cut them.
a. Right headlamp: brown/yellow
b. Left headlamp: yellow/blue
3. Use solder or a sturdy butt connector, with heat shrink tubing on all connections. Seal off harness side of cut connections. Connect a wire from the pass side LED wire to the drivers side LED wire, to the underhood fuse box.
4. Cut a relief into the edge of the fuse box to keep the wire from pinching and route to fuse 45, as this is powered at all times with the key on, and not used on the FFE.
5. Install a 5A in-line fuse and small spade connector.
6. Connect headlamps, install wire and check operation. Happy motoring!
